Garage door won't close: sensor repair in Sanibel

If the door won't close from the remote and the opener light blinks, the sensors are the first place to look.

Call (239) 360-4722

In short

A garage door that won't close from the remote is most often a sensor problem, not a broken door. In Sanibel, a technician checks the photo-eyes and wiring, resets the travel and force, and confirms the door reverses on contact before leaving. Don't bypass the sensors in the meantime.

Wi-Fi garage door opener mounted on the ceiling

Doors that won't close in Sanibel

On Sanibel the sensors sit in a ground-level garage under a raised house, open to salt air, sand and, in a storm, sea water. Nearly all were submerged in Ian. Replacements should be mounted as high as the opener allows and wired with sealed connections. Between storms, salt film and blown sand on the lenses are the routine reasons a door on the island will not close. In Shell Harbor and along the bay side, canal humidity adds to the salt. On the Gulf side, along West Gulf Drive, sea-grape leaves and sand drift into open ground-level garages daily. Homes rented by the week are a special case: guests pile beach chairs, coolers and bikes beside the door and block the beam, and the next call is that the door will not close. A clear zone marked on the floor helps.

What it means when the door won't go down

Every opener made since 1993 has two photo-eyes a few inches above the floor, one on each side of the door. If the beam between them is broken, or the opener cannot tell whether it is, the door will not close from the remote.

  • Blinking sensor light: the eyes are out of line or one lens is dirty.
  • Both lights off: no power to the sensors, usually a wire pulled loose or chewed.
  • Lights steady but the door still reverses: the problem is the close limit, the force setting, or something binding in the track.

What you can safely try yourself

Clear the doorway, clean both sensor lenses, and check that the two sensors point at each other at the same height. A steady light on each side means they can see each other. If one keeps blinking after that, or the wires look damaged, leave it for the technician.

Never disconnect the sensors or move them up out of the doorway to get the door working. They are what stops the door from closing on a child, a pet or a car.

How the repair is done

The technician tests the sensors and their wiring, realigns or replaces them, then checks the close limit and the force setting. Before leaving, the door is tested on a block of wood laid flat in the doorway: it has to reverse as soon as it touches it. If the door itself is binding in the tracks, that is corrected too, since a stiff door is often what set the opener off in the first place.

Around Sanibel

  • Beachview: Homes around the golf course mid-island.
  • Shell Harbor: Canal homes with access to the bay.

See the full Sanibel service area.

Leave the door where it is and call.

Springs and cables hold a lot of tension. Don't lift the door by hand or keep pressing the opener; call and we'll book a technician.

Call (239) 360-4722
Call (239) 360-4722