In short
If a garage door panel in Sanibel is bent badly enough that the door binds or will not close straight, stop using the opener. A bent section can crack its hinges and pull the door out of its tracks. A technician checks the damage and quotes before any work.
Panel damage in Sanibel
Hurricane Ian's surge crossed much of Sanibel, and garage doors on the East End, in Shell Harbor and along Gulf Drive spent hours in salt water. Steel sections that soaked can keep rusting from the inside for years, so a door that still runs may have panels that should be replaced. Many homes have since been rebuilt or raised with new wind-rated doors, and any replacement section must carry the same wind-load rating as the rest of the door. In The Dunes, Beachview and the West End, salt spray and blowing sand wear on the bottom rail year round. Many island homes favor coastal-style doors with windows or carriage trim, where matching appearance matters, and some communities have rules about it. Doors installed since the storm are usually easy to match; older ones may not be. Either way, you will hear what is possible before anything is ordered.
Repair one section or replace the door?
Replacing a single panel makes sense when the rest of the door is in good shape and a matching section is still available. It makes less sense when several sections are dented, when the door is old enough that its springs and rollers are also near the end of their life, or when the panel would have to be painted to match a faded door. A technician will tell you honestly which side of the line your door is on, and give both prices if a new door is worth considering.
Damage you should not ignore
Watch for a section that bows inward, hinges with cracks at the screw holes, a gap that has opened between two sections, or a door that no longer meets the floor evenly. Those are signs that the damage has spread beyond the face of the panel. On insulated doors, a crushed section can also let in water and lose its insulation value. Do not try to straighten a bent section by hand while it is on the door: the door is under spring tension, and unbolting hinges or struts can let it shift suddenly.
Matching the panel to the door
Getting the match right is most of the job. Sections come in specific widths, heights, thicknesses and patterns: raised panel, flush, carriage-style, with or without windows. Colors fade over the years, so even an exact match can look slightly brighter at first. Where wind-load or insulation ratings apply, the replacement section must carry the same rating so the door keeps it. If an exact section is no longer made, the technician will say so before anything is ordered, and explain the options, including a new door.
Around Sanibel
- Beachview: Homes around the golf course mid-island.
- Shell Harbor: Canal homes with access to the bay.
See the full Sanibel service area.